Development of a 6 degree of freedom robotic micromanipulator for use in 3D MEMS microassembly
| dc.contributor.author | Dechev, Nikolai | |
| dc.contributor.author | Ren, Lu | |
| dc.contributor.author | Liu, William | |
| dc.contributor.author | Cleghorn, William L. | |
| dc.contributor.author | Mills, James K. | |
| dc.date.accessioned | 2008-04-22T18:40:01Z | |
| dc.date.available | 2008-04-22T18:40:01Z | |
| dc.date.copyright | 2006 | |
| dc.date.issued | 2006-05 | |
| dc.description | ©2006 IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE. | en_US |
| dc.description.abstract | This paper describes the design and development of a 6 degree of freedom robotic manipulator used in the assembly of three-dimensional MEMS (micro electromechanical systems) microstructures. The robot employs a highly innovative mechanical design for the rotational axes to provide unprecedented access to a microchip substrate for microassembly operations. The first three axes of the robotic manipulator are orthogonally mounted linear stages providing Cartesian positioning of the chips beneath the end effector (microgripper). A rotational stage (alpha) mounted on the distal end of these three Cartesian axes allows the MEMS chip to be rotated. Two more degrees of freedom (beta and gamma) are serially mounted to the base frame, allowing for two degrees of rotation of the end effector. This configuration permits assembly of micro-parts on the surface of a MEMS chip at any orientation angle to the surface, within the limits of the workspace of the manipulator and the resolution of the motors. The end effector employs a standard tungsten probe with a passive microgripper bonded to it, which is used for grasping micro-parts. A software system has been developed to allow automatic operation of the manipulator. Preliminary assembly tests confirm the usefulness of the proposed design. | en_US |
| dc.description.sponsorship | Natural Sciences and Engineering Research Council of Canada (NSERC), Strategic Canadian Microelectronics Corporation (CMC) | en_US |
| dc.identifier.citation | N. Dechev, L. Ren, W. Liu, W.L. Cleghorn, and James K. Mills, “Development of a 6 Degree of Freedom Robotic Micromanipulator for Use in 3D MEMS Microassembly,” Proceedings of the IEEE International Conference on Robotics and Automation (ICRA 2006), Orlando, Florida, May 15-19, 2006. | en_US |
| dc.identifier.isbn | 0-7803-9505-0 | |
| dc.identifier.uri | http://hdl.handle.net/1828/887 | |
| dc.language.iso | en | en_US |
| dc.publisher | Institute of Electrical and Electronics Engineers (IEEE) | en_US |
| dc.subject | Micromanipulator | |
| dc.subject | MEMS | |
| dc.subject | Microassembly | |
| dc.subject | 6 DOF | |
| dc.subject | Large Workspace | |
| dc.subject | Robot | |
| dc.subject.department | Department of Mechanical Engineering | |
| dc.title | Development of a 6 degree of freedom robotic micromanipulator for use in 3D MEMS microassembly | en_US |
| dc.type | Article | en_US |